Process flow of metal carved board

Metal carved panels are a new type of material in the building materials industry. It is very long and has many different styles and patterns. It looks Very beautiful, it all depends on its craftsmanship, the following metal carved board manufacturers will introduce its craft flow to everyone

Cheng:

External wall structure design of external wall insulation board system with rubber powder polystyrene particles

The system consists of a metal carved board base wall, an interface mortar layer, a polystyrene particle insulation slurry layer, an alkali-resistant grid cloth, and an anti-cracking sand. It is composed of paste protective layer and paint finish layer.

Second, the construction of the anti-cracking layer of the metal carved board:

1. After the anti-cracking is completed, spray water for curing at least 3 times, with an interval of 24 hours each time.

2. During the construction of the anti-cracking layer, it is advisable to start from the top layer along the outer corner of the wall, and spray water on the cured insulation layer to wet the insulation layer, and then Apply 3mm anti-cracking mortar, and then lay alkali-resistant grid cloth when it is not dry.

3. The overlap between the planes of the alkali-resistant grid cloth should not be less than 50mm, and the overlap between the yin and yang corners should not be less than 150mm, and the yin and yang corners should be fixed. Before alkali-resistant grid cloth, the alkali-resistant grid cloth should be folded into a 90° right angle to facilitate construction.

4. At the transfer and plastering part of bricklaying and reinforced concrete: external hanging width 300 hot-dip galvanized steel wire mesh 12.7x12.7x0.9, 150 per side Wide, the steel mesh overlaps 100 wide, fixed with anchor bolts, and can be plastered.

5. Two people should cooperate when laying, the middle person presses the alkali-resistant grid cloth, and the other-the person presses the alkali-resistant grid cloth into the anti-crack with a gray board In the mortar, when there is a part of the grid cloth leaking, it is then covered with a crack-resistant mortar to reach the level of exposure.

Third, the construction technology and key points of the external thermal insulation of rubber powder polystyrene particles

Process flow:

Insulation decorative board base surface wall cleaning-hanging vertical line-> plastering cake-> hanging wire mesh-> coating interface mortar-→ 15mm ordinary plastering Hair → Hanging vertical line → Plastering cake reinforcement-> Plastering polystyrene particle slurry-> Plastering anti-cracking mortar-Pressing into alkali-resistant grid cloth-→ Coating material.

The metal carved board has a good sound insulation effect and will not make everyone feel because of its good heat preservation in the cold winter.

It is very suitable for use in winter when it is cold.